Trying to reach one computer from the internet with a D-link router

[Tortanick]

I've got a domain that points to my IP, this is a single IP for several computers, and when I type in my domain as an URL i get the router configuration page

I've set the following ports to point to the Lan url of my server:
21 22 25 53 80 81 110 143 443 631 953 993 995 1026 1027 3306 3370

How do I get it that entering my domain will end up at my server not my router?

[degsy]

Port80 should do it. Make sure you haven't got your router Remote Connection set to Port80.

[Tortanick]

shields up dose say the ports are open, but I've checked a bit and I don't think its actually forwarding anything

[degsy]

If you are seeing the router then it is a problem there. Make sure you are forwarding Port80 on TCP in the router config.

It may be set in the uPnP Forwarding settings.

[Tortanick]

I'm forwarding it on both TCP and UDP

as for uPnP, it simply an on off switch. I turned it on but it didn't make any diffrence

[degsy]

Is your webserver running and is it on Port80?