Azureus NAT problem - Static IP

[edge333]

Hey everyone,

I have a NAT problem with Azureus. I have checked the wiki and talked on the irc with many people but I can't figure it out. So here goes:

I use Windows XP. I have a Arris Touchstone Cable Modem 300B. I have two routers: one, the Linksys BEFSR41 v. 4, has the same exact IP address as a device listed on the DCHP client table of the second router, which is a Linksys BEFSR81 v. 3. So I have one secondary router that is the client of another router. My question is, how do I set up a proper static IP address if the secondary router's local network IP address is 192.168.10.1 but the actual IP is 192.161.1.103. The primary router's local network address is 192.168.1.1, of which the other router is connected to? I know it doesn't matter what port I use for port fowarding but I'm just not sure what to do about the IP address. I know for a fact that 192.168.10.2 doesn't work. I can't even connect to the internet with that IP address. Any help?

[degsy]

Welcome :)

If you are connected to the secondary router then you need to assign yourself an IP in that sub network.

In the Primary router you will have to forward the port to the Second Router's Default Gateway IP.
On the Secondary Router you will have to forward the port to the static IP.

[18Googol2]

This is comprehensive guide for port forwarding:

http://www.portforward.com/routers.htm