Networking Vista & Xp!

[daffy duck]

I am going to be purchasing a new p.c. and I need to network with my other two p.c.'s, I will have vista and the others xp. Will this cause problems?

[Murf]

No and Yes.

But it takes some manual tweaking to get a mixed Vista/XP network to work properly.

The Windows Vista Network Map -- which may be the best networking feature Microsoft has ever introduced into Windows -- won't work properly with XP PCs. They won't show up properly on the network map, if they even show up at all.

Fixing workgroup woes
The first problem is that the default name for your workgroup on the network has been changed from Windows XP to Windows Vista. In Windows XP, the default name for the network is Mshome; in Windows Vista, it is Workgroup.

This is an easy fix;
You can change the name of the workgroup on Windows XP to match the name of your Windows Vista network. On Windows XP, right-click My Computer, click the Computer Name tab, then click Change. The screen shown nearby appears. In the Workgroup box, type in the name of your Windows Vista network name. If you're leaving it as the default used in Windows Vista, type in Workgroup. If you're not using the Windows Vista default, change it to whatever name you've given your Windows Vista network and click OK.

You can, instead, give your Windows XP and Windows Vista machines both new workgroup names, as long as they match. To change the name of your workgroup in Windows Vista, right-click Computer and select Properties. You'll see the name of your PC as well as its workgroup name. Click Change Settings, then from the screen that appears, click Change. In the dialog box, shown in the figure below, type in the new name for your workgroup and click OK.

A bigger problem has to do with the new Windows Vista network map.
The network map is possibly the best addition it comes to networking that Windows Vista has made. To get there, select Control Panel --> Network and Internet --> Network and Sharing Center --> View full map.

The map shows you all the PCs and devices attached to your network -- those in your entire network, not just your workgroup. This map is more than nice to look at; it's extremely useful as well. Hover your mouse over any device, and you'll be shown information about it, such as its name, IP address and MAC address, as shown in the figure below. Click a PC and you'll connect to it.

There's a problen, though. When you look at the bottom of the screen in the network map Vista drew of the network. You'll see a number of devices listed. Windows Vista has found them, but doesn't quite know what to make of them. It can't figure out where they fit in on the network. And it won't give you any information about them if you hover your mouse over them.

The problem is that to discover information about devices, Windows Vista uses a new protocol, called Link Layer Topology Discovery. LLTD is built into any Windows Vista PC, which is why they show up properly on the network map. However, LLTD isn't built into Windows XP, which is why they don't show up properly.

There is a Patch to fix this:

Here

Other then the above it should work OK......

[daffy duck]

oooh! sounds complicated, maybe I just stick to xp