Installed Win ME then . . . nothing!

[struggling]

Help! Installed ME on clean, formatted, FAT32 2Gb partition. All went smoothly until final reboot. Then, after initial DOS-type boot-up screens, when I expected something like 'Starting Win ME' and an ME splash screen, I had a blank screen except for a flashing message 'Signal Out Of Range'. Starts OK in safe mode. Other times, gives the above message, or just completely blank screen.
AMD K6-2 500MHz (not o/clocked), 30Gb Maxtor HDD, 128mB RAM, ATI All-In-Wonder 128.
What am I doing wrong?
Thanks.

[Geordie No 1]

What does your Device Manager reveal? Have you installed all other software for graphics etc. also?

[struggling]

Device manager shows everything to be OK.
Have started up in safe mode and navigated to the display adapter settings, advanced. The only options I have for refresh rate are 'Optimal' (default setting) and 'Adapter Default'. I changed to A.Default and restarted WinME.
The display resolution was low with 16 colours, so I attempted to change these - could not. No settings available other than the lowest.
Attempted to install latest ATI driver (which I have also used in Win98 with full functionality) to no avail - the system again refused to boot (Signal Out of Range).

Sorry about length of time to post back - I've had to re-install W98. Still like to crack this, though, if possible.

[struggling]

After much installing and removing of drivers for ATI card and Dell monitor, and installing/re-installing Win ME, I finally realised that the problem lay with the AGP drivers required by my mobo. Once these were updated Win ME started up as expected. Many thanks.