BITS Not Working In Win 7 Cannot Start Service Not Found

[Zantharas]

I have Windows 7 Ultimate v6.1.7600 x64

Windows Update gave me the error code 80246008

We followed instructions in help & support as follows>>

Windows Update error 80246008

You must be logged on as an administrator to perform these steps.

If you receive Windows Update error 80246008 while downloading updates, you might need to change the Background Intelligent Transfer Service (BITS) or Windows Event Log service settings, and then restart each service.

To change or restart the Background Intelligent Transfer Service (BITS)
Click to open Administrative Tools.

Double-click Services. If you're prompted for an administrator password or confirmation, type the password or provide confirmation.

Right-click the Background Intelligent Transfer Service (BITS) service, and then click Properties.

On the General tab, next to Startup type, make sure that Automatic (Delayed Start) is selected.

Next to Service status, check to see if the service is started. If it's not, click Start.

To change or restart the Windows Event Log service
Click to open Administrative Tools.

Double-click Services. If you're prompted for an administrator password or confirmation, type the password or provide confirmation.

Right-click the Windows Event Log service, and then click Properties.

On the General tab, next to Startup type, make sure that Automatic is selected.

Next to Service status, check to see if the service is started. If it's not, click Start.

If the problem persists after you have followed the steps above, go to this Knowledge Base article on the Microsoft Help and Support website or go to the Microsoft Update Solution Center website to request support by e‑mail.

Error codes this applies to:

WindowsUpdate_80246008

0x80246008

--------------------------------------------------------

The BITS service says that it cannot start on the local machine
error: 126 The module could not be found

I found the Vista Version of the BITS repair toolkit at the following link>>

http://support.microsoft.com/kb/940520

but it says Vista Only.. Please what do I do to correct this problem??

Dependancy Walker says the IESHIMS.DLL file cannot be found

Thank you for your time and attention to this issue..

Namaste...

Zantharas

[Spider]

Hi Zantharas welcome to Cyber Tech Help.

Open a Command Prompt and type...

regsvr32 qmgr.dll hit enter
then
regsvr32 qmgrprxy.dll hit enter

[Zantharas]

The repair you suggested did not work... it could not find the module, cbut I finally managed to find One.. system restore point that DID.. work.. Everything is back to normal.. PFEW!!! What a nachtmar. Thanks for the assist all the same.

[Spider]

Good that it all worked out. Thanks for posting back with your fix.