View Single Post
Old December 21st, 2010, 03:32 AM
violetlass violetlass is offline
New Member
Join Date: Dec 2010
Posts: 1
I have a question, I have it installed perfectly, but how can I get COM 1 port to turn on, it is recognized by my program, but the hardware at the other end isn't recognizing that the port is opened. On set up it says the value is none, how can I change that with out it being com 3 or 5 and it being unrecognized. I am using a USB to 9 pin(male) serial port.

Fixed it, my PC has it listed as COM 5.

Last edited by violetlass; December 21st, 2010 at 07:28 AM.
Reply With Quote